I believe that through introduction before, everyone on the jaw is no longer strange, application of jaw crusher in the industrial production is quite extensive, because the scope of its application is more extensive, comparison of the characteristics of higher equip ment efficiency, are favored. So for the jaw crusher is also on material machining a big advantage of equipment. The following, we for the jaw crusher is composed of a comprehensive understanding, and familiar with its use matters needing attention: first, the jaw crusher is composed of jaw crusher parts mainly includes jaw, eccentric shaft, a spring seat, a belt pulley, a toothed plate lining board (also known as dental plate, plate), edge the guard plate, a pressing block, a pressure head, a thrust plate, end cover, shaft, the movable jaw, a casing, jaw crusher jaw plate of high manganese steel casting products, combined with the advantages of high strength and abrasion resistance, the breaking capacity and service life of the jaw is greatly improved. Also need to note is, as one of the broken equipment at present in the production line of the most widely used, the choice of jaw crusher high production efficiency is undoubtedly a great. This type of crusher and traditional compared, operation more convenient, and the production efficiency is increased a lot. Of course, in order to ensure the maximum production efficiency, operating personnel must be in strict accordance with the requirements of production operation in the operation of the process. The jaw crusher, because its principle is more complex, there are a lot of jaw type crusher based operations, the following specific introduction: in the jaw crusher machine operation process, should always observe the rotor main bearing temperature, generally, normal temperature at sixty degrees Celsius, the highest temperature not exceeding seventy-five degrees celsius. If it is found that the temperature change is big, beyond the specified value, must promptly report the relevant amount of maintenance personnel, processing timely stop, until the solution to start again. The principle of selective crushing machine complex, at run time, the general will produce a lot of dust, in addition to the dust collecting equipment work, but also the corresponding set in the room. With all the work finished, the shutdown process, first of all to put fine jaw crusher power to cut off, then check whether there are residual crushing cavity inside the waste, timely removal, only after all the materials is exhausted, can stop the operation of main motor. In addition to equipment storage generally placed in ventilated and dry place, avoid by all means is put in wet rooms, rust corrosion this will exacerbate the equipment.

Resource:

http://www.crusherschina.com/products/crushing/pe-jaw-crusher.html