oracle 10g安装时参数校验,遇到提醒:
英文提示如下:
Checking Network Configuration requirements ...
Check complete. The overall result of this check is: Not executed <<<<
Recommendation: Oracle supports installations on systems with DHCP-assigned public IP addresses. However, the primary network interface on the system
should be configured with a static IP address in order for the Oracle Software to function properly. See the Installation Guide for more details on
installing the software on systems configured with DHCP.
中文提示如下:
正在检查网络配置需求...
检查完成。此次检查的总体结果为: 未执行 <<<<
建议案: Oracle 支持在具有 DHCP 分配的公共 IP 地址的系统上进行安装。但应使用静态 IP 地址来配置系统的主网络接口, 以便 Oracle 软件正常工作。
有关在配置有 DHCP 的系统上安装软件的详细信息, 请参阅 Installation Guide。
cd /etc/sysconfig/network-scripts/
[root@test network-scripts]# cat ifcfg-eth0
# Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
DEVICE=eth0
BOOTPROTO=dhcp
HWADDR=00:14:C2:5C:86:07
ONBOOT=yes
[root@test network-scripts]# cat ifcfg-eth1 --这块是主网卡,没有注明是否使用静态IP
# Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
DEVICE=eth1
HWADDR=00:14:C2:5C:86:06
ONBOOT=yes
HOTPLUG=no
IPADDR=10.70.10.120
NETMASK=255.255.255.0
GATEWAY=10.70.10.254
[root@test network-scripts]# ifconfig
eth1 Link encap:Ethernet HWaddr 00:14:C2:5C:86:06
inet addr:10.70.10.120 Bcast:10.70.10.255 Mask:255.255.255.0
inet6 addr: fe80::214:c2ff:fe5c:8606/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6887939 errors:0 dropped:0 overruns:0 frame.:0
TX packets:2168753 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6328032096 (5.8 GiB) TX bytes:308981538 (294.6 MiB)
Interrupt:225 Memory:fdee0000-fdef0000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:68941 errors:0 dropped:0 overruns:0 frame.:0
TX packets:68941 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:295438854 (281.7 MiB) TX bytes:295438854 (281.7 MiB)
[root@test network-scripts]# cat ifcfg-eth1
# Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
DEVICE=eth1
BOOTPROTO=static --增加了这条, 解决了。
HWADDR=00:14:C2:5C:86:06
ONBOOT=yes
HOTPLUG=no
IPADDR=10.70.10.120
NETMASK=255.255.255.0
GATEWAY=10.70.10.254
来自 “ ITPUB博客 ” ,链接:https://blog.itpub.net/10173379/viewspace-732573/
,如需转载,请注明出处,否则将追究法律责任。